Home > Beep Codes > Dell Vostro Error Codes

Dell Vostro Error Codes

Contents

An error occurred during the tests that may involve the main system board of the system. Next Steps PSA NA ePSA 2000-8001 (Not used with UEFI BIOS) BIOS - No BIOS support for software interrupt [x] function[x] [x] The motherboard BIOS revision may not be current. BIOS detected a cable that was not installed. You can get more information on possible resolutions to your issue and even get a part dispatched if needed. Check This Out

GATE A20 FAILURE A memory module may be loose. Turn off your computer and connect the cable that is described in the string portion of the message (see your service manual for instructions). Reinstall the memory modules and, if necessary, replace them. Shut down the computer, remove the hard drive, and boot the computer from a CD.

Dell Inspiron Beep Codes

EXIT SOME PROGRAMS AND TRY AGAIN You have too many programs open. If the diagnostics still results in an error code, visit our ePSA online tool. Memory size in CMOS invalid The amount of memory recorded in the computer configuration information does not match the memory installed in the computer. When a test fails, the user is notified via POST codes, Light codes, or Beep codes.

Reseat the USB Device. Can you run the DST, PSA and ePSA diagnostics on already encrypted Full Drive Encryption (FDE) drives? Repeat the PSA diagnostics. Dell Beep Codes 1-3-2 Install compatible memory modules.

Reinstall the memory modules and, if necessary, replace them. Dell Inspiron Beep Codes 4 Beeps Select the program you want to remove. Desktop systems, if a PCI-E graphics adapter is installed in the system, reseat the card and any internal power connections to the card. http://www.dell.com/support/article/us/en/19/SLN293445 The computer failed to complete the boot routine three consecutive times for the same error.

NO BOOT SECTOR ON HARD DRIVE The operating system may be corrupted. Dell Error Codes Lights Update to the latest BIOS. Repeat the PSA diagnostics. The device is not ready The floppy drive cannot read the disk.

Dell Inspiron Beep Codes 4 Beeps

September 17, 2015 3:08 pm Hard Drive Formatting How To Guide... http://www.dell.com/support/article/us/en/4/SLN115162/en If the diagnostics still results in an error code, visit our ePSA online tool. Dell Inspiron Beep Codes Update to the latest BIOS. Dell Optiplex Beep Codes Turn off your computer and remove and replace the battery (see your service manual for instructions).

l Flashing orange—The battery charge is low. his comment is here Update to the latest BIOS. For another operating system, run the appropriate corresponding utility. Replace damaged cables or devices. Dell Beep Codes 5

DISK C: FAILED INITIALIZATION The hard drive failed initialization. Repeat the PSA diagnostics. Lucia St. http://infiniglobalnet.com/beep-codes/dell-vostro-error-beeps.html Vostro Beep Codes The computer might emit a series of beeps during start-up if the display cannot show errors or problems.

Diskette drive 0 seek failure A cable may be loose or the computer configuration information may not match the hardware configuration. Dell Xps Beep Codes If the diagnostics still results in an error code, visit our ePSA online tool. Your hard disk drive has indicated a failure.

Connect your computer to an electrical outlet to charge the battery.

Run the System Set tests in the Dell Diagnostics. This may take 10-15 minutes depending on the hardware in your system. February 13, 2012 12:20 pm Dell Inspiron1420/Vostro 1400 (PP26L) LCD Screen Removal and Installation... Dell Dimension Beep Codes The delay between each beep is 300ms.

PSA 1000-0143 ePSA 2000-0143 Hard Drive - SMART read command unsuccessful. See Windows Help and Support for instructions (click Start > Help and Support). If the diagnostics still results in an error code, visit our ePSA online tool. http://infiniglobalnet.com/beep-codes/dell-vostro-error-lights.html BIOS Chip System board failure, covers BIOS corruption or ROM error 2 No RAM Detected No memory detected 3 Chipset Error (North and South Bridge Chipset, DMA/IMR/Timer Error for Intel platform);

Doing this may result in a false error being reported. Windows 7: Click the Windows 7 start button > Control Panel > Programs and Features. Power LED Blinking/Beep Code LED/Beep Code Fault Description Fault(s) Suggested Action 1 Motherboard: BIOS ROM Failure Motherboard, covers BIOS corruption or ROM error Run the Dell Diagnostics 2 Memory No Memory For further information on running the online diagnostics, please refer to the article How to use the Dell Online Diagnostic Tool to troubleshoot your Dell PC for more information.

Update the BIOS to the most current version and the issue should resolve. Back to Top How to use a ePSA Error Code to Help Resolve Your Issue After Running the ePSA Diagnostics. An error occurred during the tests that may involve the main system board or memory of the system. MEMORY DOUBLE WORD LOGIC FAILURE AT ADDRESS, READ VALUE EXPECTING VALUE A memory module may be faulty or improperly seated.

There may be an issue with the system board, memory, processor or the power supply. PSA NA ePSA 2000-0711 Thermal - Thermal trip detected. Update to the latest BIOS. Power down system and reseat memory.

MEMORY WRITE/READ FAILURE AT ADDRESS, READ VALUE EXPECTING VALUE A memory module may be faulty or improperly seated. If the diagnostics still results in an error code, visit our ePSA online tool. Repeat the PSA diagnostics.